How to convert CCcam line to Oscam Reader?

1. Understand the Basics:
   • A CCcam line typically looks like this:
     C: server_address port username password
   • An OSCam reader configuration in oscam.server format looks like this:
     [reader]
label = my_reader
protocol = cccam
device = server_address,port
user = username
password = password group = 1
2. Create an OSCam Reader:
   • Open your oscam.server file (usually located in /etc/tuxbox/config or a similar directory).
   • Add a new reader section (replace placeholders with actual values):
     [reader]
label = my_reader
protocol = cccam
device = server_address,port
user = username
password = password
group = 1
     • label: Choose a unique label for your reader (e.g., my_reader).
     • protocol: Set it to cccam.
     • device: Specify the CCcam server address and port.
     • user and password: Use the credentials from your CCcam line.
     • group: Assign the reader to a specific group (if needed).
3. Save and Restart OSCam:
   • Save your changes to oscam.server.
   • Restart OSCam for the new reader configuration to take effect.
4. Test the Configuration:
   • Use the OSCam WebIf or command line to check if the reader is connected and working.
   • Verify that the reader status is “connected” and that the card data is being read.

Remember to adjust the configuration according to your specific setup. Now you can enjoy your CCcam channels using OSCam! 📡🔑